Hey All / jokiin
Anyone have experience with installing the fuse taps to allow the cam to enter parking mode for a 2018 Mazda 6?
Ive tried a number of different points but the cam turns off every time I turn the ignition off.
Even tried to follow the install guide for a 2018 CX-9 to give me an idea to what to tap into but no dice.
If I pull the ACC wire from the fuse box as per jokiin's instructions, it will enter parking mode.
I'm guessing I'm tapping into the wrong points but the multi-meter was showing they should have been fine.
Separate to this issue, there are 2 other issues I've encountered.
Anyone have experience with installing the fuse taps to allow the cam to enter parking mode for a 2018 Mazda 6?
Ive tried a number of different points but the cam turns off every time I turn the ignition off.
Even tried to follow the install guide for a 2018 CX-9 to give me an idea to what to tap into but no dice.
If I pull the ACC wire from the fuse box as per jokiin's instructions, it will enter parking mode.
I'm guessing I'm tapping into the wrong points but the multi-meter was showing they should have been fine.
Separate to this issue, there are 2 other issues I've encountered.
- The cam will not automatically turn on if the car is left off for more than a few hours / overnight. I need to turn it on manually.
- Intitially, the hardware harness / fuse taps didnt sit tightly into the low profile fuse holder.
Looked like the fuse holder retaining clip was holding the fuse tap out far enough not to allow it to engage properly.
Ended up taking to the fuse tap with a craft knife and cut out a relief to allow the tap to sit in deeper / tighter.