That's ACC circuitry. The other one stays ON at all times.5v output, will switch 0v when parked
That's ACC circuitry. The other one stays ON at all times.5v output, will switch 0v when parked
yess, was only referring to the ACC sideThat's ACC circuitry. The other one stays ON at all times.
what will be the differences between SGDCHW and cable builded by Viofo?
Ok, Thanks! I mean, is SGDCHW compatible with viofo a129?I haven't done side by side comparison so I couldn't say for sure, functionally the same but I think the connectors are maybe different
Ok, Thanks! I mean, is SGDCHW compatible with viofo a129?
i.e. ACC Wire status:5v output, will switch 0v when parked
i.e. ACC Wire status:
0v = Park mode,
5v = Normal mode
?
For mini0906 - in reverse (5v = Park mode).
So it's easy to get ACC output (resistor + 3,9v stabilitron).yes they do it differently on that model from what I understand
So it's easy to get ACC output (resistor + 3,9v stabilitron).
If you have it, could you post pictures of the inside?I haven't done side by side comparison so I couldn't say for sure, functionally the same but I think the connectors are maybe different
If you have it, could you post pictures of the inside?
Power and rear camera cables. Both cables have 90 deg connectors. Does not look good. Needs an extension of sorts on the power cable.
View attachment 41780
Just note that one of your piggy back fuses are around the wrong way.Just installed the sample kit. Here are some pictures.
Fuse box with connections. I added a fused link to ACC also.
View attachment 41776
Grounding wire
View attachment 41777
Module double taped to sidewall next to fuse box
View attachment 41778
Camera with the 2 connections. Power now goes to camera, not GPS. GPS works properly
View attachment 41779
Power and rear camera cables. Both cables have 90 deg connectors. Does not look good. Needs an extension of sorts on the power cable.
View attachment 41780
Using firmware https://drive.google.com/open?id=1jGB1XE39zhWk-oU-k4IWOtYqNCXYrfu9 with parking mode in Auto.
Testing just beginning. Will post info tomorrow.
I did use a multimeter. I installed them only after that. The 2 rows of fuses have 12V on the sides facing each other. Just for you, mate I'll check it again tonight.Just note that one of your piggy back fuses are around the wrong way
("connector is facing the wrong way ")
---
May I use standard miniUSB jack instead of native power cord ?
Are they compatible ?
So the wait continues and the cam remains in the box .....We are still improving the cable, need more testing before final release.