mjo13
New Member
Apologies if this has already been covered, but haven't seen this topic when scanning thru the other threads.
I have the SGGCX2PRO+ (Front and Rear w/ hardwire kit), purchased in October 2019. Firmware version V1-29.
I have the Loop Recording setting set at 3 minutes. I've noticed that occasionally there will be a 30 to 40 second gap between the end of one recording segment and the beginning of the next segment. When reviewing footage on the card, this seems to occur for 40-50% of the segments. Obviously this is concerning because it doesn't appear anything was recording during these gaps.
Is this typical or do I have a bad SD card, or something else? I have the Transcend 32GB card that came with the dash kit. I always reformat the card when reinserting into the camera. Also just checked the SD card with the h2test software and it doesn't appear to have any faults.
Thoughts?
I have the SGGCX2PRO+ (Front and Rear w/ hardwire kit), purchased in October 2019. Firmware version V1-29.
I have the Loop Recording setting set at 3 minutes. I've noticed that occasionally there will be a 30 to 40 second gap between the end of one recording segment and the beginning of the next segment. When reviewing footage on the card, this seems to occur for 40-50% of the segments. Obviously this is concerning because it doesn't appear anything was recording during these gaps.
Is this typical or do I have a bad SD card, or something else? I have the Transcend 32GB card that came with the dash kit. I always reformat the card when reinserting into the camera. Also just checked the SD card with the h2test software and it doesn't appear to have any faults.
Thoughts?