Hi boys! I have a realy big problem with my Viofo A119 V2.
So, today i set the cablages and the dashcam. I bougth and Hardwire set with 3 cables as just my father bought for his Goluk T1. The 3 wires are for : yellow for the ACC (when you put the key the camera starts to records), the +12V from which camera can record in parking mode (when the key is off) and the negative.
But when i connect the camera (even if there wasn't the key in) and without any moviments the camera immediatelly starts to record
while in parking mode of if they see movements should be start recording, right?
Then when i put in the key and start the engine tha camera continue to record.
I shot down the engine and take out the key and the Dashcam didn't change its status in parking mode but continie to recording as if the engine is working.
My father goluk when start the engine stars recording, when he stop the car and shot down the engine automatically commute to parking mode that only record if there is movements and not recording however! Then if he restart the engine the goluk start immediatelly to record..
Is there any problems? The cablages are correct and the yellow goes to ACC fuse of car and the red to +12V constant of the fuse car.
So what it could be? Why when i shot down the engine the camera wouldn't shot down and wait to recorder only when it see movements?
I link some photos and videos of problems.
Thanks
Inviato dal mio SM-G935F utilizzando Tapatalk