Need some help. I'm getting this:
Found 1 YDXJ device!
Init DRAM ok.
[0] Wait device re-init...
[0] Not found.
BLD execute failed.
[0] Failed!!
I tried using DirectUSB to EraseNand and it also fails.
Any ideas?
Well, i had the same problem but don't worry, you're on the right way ;-)
First, choose the right file (depending on serial number cam) to donwload on the combo box...
In order to do the update, you need 3 hands...:
one to keep power button pressed
the other to do a short-circuit on the board.
and your third hand to press connect (so i asked my wife to do that when i was ready)
In windows 7, i had noticed that my computer made the same sound to install a new driver when "the power/short-circuit" operation is done but it didn't find the driver...
So i've first installed the driver "ambarella manually 1.2.3" and finally windows found the driver (which was installed manualy).
Until, the driver was not intalled, i had a "fail" message even if the program found the device...
When the driver is installed, i removed my hands from the camera and i pressed download and it works i have "done" after few time.
After that, I've installed the last driver (september/october) on the cam (download it from Xiaomi : depending on serial number).
Remaming the file "firmware.bin" and put it on SD card "root".
Now, my camera operates normaly